Started Making Barrel Bend

I am not going to post many details as I don't know if this is going to work or not. However, I did make some progress making the machined barrel bends today. Plus the PVC glue does seem to be be at least as strong as the PVC itself. So this might just work. If it does then it should trim amost two inches off of the height of Nassau's barrels. I am hoping to install them at scale height. Here are a few random pictures from today.

Above is a picture of two parts in my Barrel Bend Holder. The little jig worked better than I expected. Below are some pictures of the parts before gluing and after. The after picture includes an extra center part (to left) so that you can see the internal structure as well.